Mefar 2000 Nebuliser Cup with Connector

NEBULISER CUP
Mefar2000

Class IIa medical device.
Intended for administering medicines to the patient in aerosol form. Administration must be prescribed by a doctor, specifying the type of medicine, the doses to be administered and the duration of treatment.

Directions for use
To avoid the risk of microbial contamination, the components must be cleaned and disinfected after each treatment and before use, carefully following the instructions listed.
Cleaning
The nebuliser cup, mouthpiece and nosepiece with connector must be washed in hot water using a little non-abrasive detergent and rinsed under running water. Once all parts have been cleaned, they can be dried with a soft cloth or a hairdryer and then put away.
Disinfection
After washing, the nebuliser cup, mouthpiece, nosepiece with connector and tube end can be immersed in a cold disinfectant solution (such as a 5.25% sodium hypochlorite solution), following the manufacturer's instructions (caution: consult the warnings to check that the disinfectant solution is compatible with the material of the kit). The kit components, except the tube end, can be disinfected by boiling them in water for 10 min.
Sterilisation
The kit components, except the tube end, can be sterilised in an autoclave at 121°C for 15 min. (preferably not exceeding 30 min.).

Technical specifications:
Minimum supply pressure: 1.5 bar (150 kPa)
Maximum supply pressure: 3 bar (300 kPa)
Air flow at minimum pressure: 7 l/min
Air flow at maximum pressure: 15 l/min
Medicine output at minimum pressure: 0.20 ml/min
Medicine output at maximum pressure: 0.45 ml/min
MMAD at minimum pressure: 2.5 µm
MMAD at maximum pressure: 1.9 µm
Maximum capacity: 8 ml

Components
Nebuliser cup, mouthpiece and nosepiece (with connector): polycarbonate.
Aerosol tube end: PVC.
No natural latex detected.
No phthalates detected.

Size
1 piece.

Code 471130